Wifi module has a limit for transmission rate, carving time can not be too short, mobile terminal carving can get rid Shutting down the screen orĬlose wifi will cut the online connection and terminate the engraving process. Make sure mobile phone is turned on and doesn’t exit from mobile phone software. Of unstable device like usb concentrator ,low quality power supply or small current charger pal.ĥ.Carving stopped suddenly when controlled by mobile phone Rotate focusing cap on the laser head to minimize the spot to a concentrated smaller point.carved subjects ofĭifferent heights require refocusing to match well.The better refocusing effect is, the better will carving effects be.įirst make sure carved objects are not burning products like metal or ceramics.after that, see if laser refocusĪccurately or if burning time is set too short.Ĥ.machine continues to restart,or restarts at the beginning of carvingĬheck the power line to make sure all are attached to 5v power, if there is no problem,check if power supply is a kind System haltsĬut off two power lines and restart the machine, reopen upper monitor of computer or mobile phone and reconnect The following videos are the instructions about HTPOW 1000mW non-wifi and wifi laser engraver. ![]() 303 laser astronomy laser pointer cat laser pointer keychain laser pointer
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |